TS-CCA-VSFD002S/B - Performance Intercooler Upgrade Suit Ford Ranger RaptorUpdated 7 hours ago

Product Name:	Performance Intercooler Upgrade suit Ford Ranger Raptor
Product Description:	Air to Air Intercooler
Product Number:	TS-CCA-VSFD002S/VSFD002B

Important notes on your new Intercooler

Turbosmart accepts no responsibility whatsoever for incorrect installation of this product which is potentially hazardous and can cause serious engine damage or personal injury.
Turbosmart intercoolers is designed for use as a factory replacement for a turbocharged vehicles OEM intercooler.
Ensure the engine is cold prior to installation.

Recommendations

Turbosmart recommends that your intercooler is fitted by an appropriately qualified technician.

Kit Contents

Part	Description	Use
1	Turbosmart Intercooler	Main unit
2	Instruction Card	Instruction Card
3	Turbosmart Sticker	Turbosmart sticker

Tools Required

Allen key set metric

Screwdriver

Basic socket set

Torx bits

Fitting your Intercooler

Identify intercooler location

On the 2nd Generation Ford Ranger Raptor (P703/RA) 2022+ the intercooler is located at the front of the vehicle located on the lower portion of the car behind the number plate. It is easily accessible from the bottom of the car.

NOTE!

Allow for the engine to cool down.

Removing the Undertray

Remove the under-tray of the vehicle by removing all the plastic clips holding the tray in place. Once the under-tray is removed, the intercooler assembly can be accessed. This is done by removing the front two 15mm bolts and loosening the rear two bolts.

Undo the two 10mm holding the intercooler ducting onto the tow eye/intercooler mount.

Undo the bolts securing the intercooler mounts/Tow eyes to remove the intercooler from the vehicle. The Intercooler undertray is held on with 2 x 15mm bolts per mount

NOTE!

It may be required to remove auxiliary components to access the intercooler, ensure you consult your local specialist or a service manual for correct disassembly procedures.

Remove Intercooler Piping

The intercooler piping is held on with a quick release clip. Once these are removed the pipe can be wiggled free.

Refitting Intercooler to Car

With everything fitted back to the intercooler we can fit the intercooler back into the car. It’s helpful to use the intercooler bracket to assist with the intercooler to remain in place.

The turbo feed pipes as well as charge pipe to the throttle body must be refitted, the charge pipe needs an audible click to sound from the retention clip as well as the hoses from the turbochargers.

Refitting Undertray

Refit Undertray with the 2 x 15mm bolts that were moved to originally gain access to the Diverter valve area.

Finalising your Install

It is important to check for leaks and correct operation, ensuring no leaks are present and all hoses are correctly seated.

TROUBLE SHOOTING

Diverter valve not actuating - Confirm electrical signal plug is connected appropriately, as the plugs are new, some force may be required to click the plug into place.

Valve is staying open - Confirm the valve has O-rings as they may have been dropped or lost during installation.

Boost Pressure loss or lower than before - Confirm the valve has O-Rings as they may have been dropped or lost during installation. Intercooler Pipes are correctly seated.

Failing the above, submit a technical request to [email protected] with information of your engine configuration and photos of installation.

As the factory engine control unit controls the valve, the diverter valve is almost silent.

Was this article helpful?

Yes